Download Free 3D Model 15mm x 5mm magnet holder 3D Print Model

Summary
15mm x 5mm magnet holder.
The hole for the magnet is a little undersized so the printed part can be heated a little (eg hot water if using PLA) and press fit. Or use some glue or if your magnet has a hole in center – a screw. I went with heating and press fit and its been solid.
i didn’t use any support when printing, the inside roof of the hole where the magnet goes is a fair span (15mm of unsupported distance) and so that particular surface wasn’t perfect but it worked fine and its behind the magnet anyway – doing this saves breaking out support material.
Print Settings
Printer:
aldi cocoon
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
no