3DHunt.co

Tag: 15mm

  • 15mm x 5mm magnet holder 3D Print Model

    15mm x 5mm magnet holder 3D Print Model

    Summary
    15mm x 5mm magnet holder.
    The hole for the magnet is a little undersized so the printed part can be heated a little (eg hot water if using PLA) and press fit. Or use some glue or if your magnet has a hole in center – a screw. I went with heating and press fit and its been solid.
    i didn’t use any support when printing, the inside roof of the hole where the magnet goes is a fair span (15mm of unsupported distance) and so that particular surface wasn’t perfect but it worked fine and its behind the magnet anyway – doing this saves breaking out support material.
    Print Settings
    Printer:
    aldi cocoon
    Rafts:
    No
    Supports:
    No
    Resolution:
    0.2mm
    Infill:
    no