Download Free 3D Model Mk.10 Extruder Silicone Cover Mould 3D Print Model

Summary
This is a mould for a high temperature silicone insulator for the MK10 heater block as fitted to the Wanhao i3 Plus and other printers. Gives a 3mm insulating shell around the outside of the block with ports for the cartridge and thermistor wiring.
Post-Printing
Parts required
You’ll need 4xM4 screws and nuts to bolt the two halves of the mould together. The flanges are 3mm thick so M4x10 should just about do it.
To mould you’ll need to fill half the mould with your silicone – if you can’t get a runny 2 part mix then try to pipe it into the corners. Push the insert in and make sure the silicone is flush with the top. The cross on top should allow the cover to be removed over the insert once cured.