Download Free 3D Model Dishwasher Lower Basket Wheel 3D Print Model

Summary
I got tired of reprinting Dishwasher Lower Basket Wheel holder by Rukey all over again every couple of months, because they broke like the originals, so I redesigned the wheel holder to also include the wheel. This new design should probably have all parts thick enough not to break over time.
Fits our AEG Electrolux, should probably fit Zanussi.
Print Settings
Printer:
Minifactory 3 dual Rafts:
No Supports:
No Resolution:
0.2mm Infill:
50% Notes:
Print it from something that can withstand the heat (up to 75°C in our Electrolux) I used ABS.
Place the outer ring of the wheel so the inner ring is inside it and print it all wheel down. I use Repetier-Host, so I imported both files, set them to the same group, centered and rotated around X-axis 180°.
Post-Printing

Pry the print off the print bed, then turn the wheel (outer ring) by hand. The wheel should snap loose and turn freely.

If the axle doesn’t fit, drive a 5.5mm drill bit through the hole.
How I Designed This
I used the Dishwasher Lower Basket Wheel holder as a base for the holder and then just added the wheel at the end.
The freecad file is included in files.