Download Free 3D Model Delta arm dampener 56mm pitch 3D Print Model

Summary
This dampener is what I use as the rods I use have 56mm pitch (center to center distance on the rods) and 7mm diameter.
Others I found were much too short. I have made sure the model is sliced correctly on S3D as well as Cura etc. I have also reinforced the center arc sides a little as that seems to be where the stress can cause failures on dampeners. Also made the snapping on and off easier by rounding the inner edges of the rod grips.
I advise using PETG or ABS as PLA just isn’t great for this type of attachment.
Print Settings
Printer:
Anycubic Kossel
Rafts:
No
Supports:
No
Resolution:
0.1 – 0.2 (I prefer 0.15)
Infill:
100%