Summary
Filament Holder for 56mm Hole with 605Z Bearing
Layer high 0,2mm
Print Settings
Printer:
CR10S
Rafts:
No
Supports:
Yes
Infill:
15%
Tag: 56mm
-
Filament Holder 56mm with Bearing 608Z 3D Print Model
-
Delta arm dampener 56mm pitch 3D Print Model
Summary
This dampener is what I use as the rods I use have 56mm pitch (center to center distance on the rods) and 7mm diameter.
Others I found were much too short. I have made sure the model is sliced correctly on S3D as well as Cura etc. I have also reinforced the center arc sides a little as that seems to be where the stress can cause failures on dampeners. Also made the snapping on and off easier by rounding the inner edges of the rod grips.
I advise using PETG or ABS as PLA just isn’t great for this type of attachment.
Print Settings
Printer:
Anycubic Kossel
Rafts:
No
Supports:
No
Resolution:
0.1 – 0.2 (I prefer 0.15)
Infill:
100% -
Colt M4A1 Sopmod EOTech552 3D Model
Free File Conversions: Need this 3d model in another format? please Contact Support to verify we can provide the format you need.
-
Colt M4A1 Carbine RIS – Assault rifle 3D Model
Free File Conversions: Need this 3d model in another format? please Contact Support to verify we can provide the format you need.
-
Colt M4 Commando – Assault rifle 3D Model
Free File Conversions: Need this 3d model in another format? please Contact Support to verify we can provide the format you need.