Download Free 3D Model Berd-Air MAX Pump Bracket for Kossel Deltas 3D Print Model

Summary
I whipped this up to neatly mount my Bird-Air pump to the lower frame of my UltiBots Kossel D300VS delta. The bolt hole spacing is 40mm so the bracket can be fastened across the bottom pair of 2020 V-Slot rails with the air tube pointing forwards towards the effector “whip” mount.
Position the bracket on the “whip” side of the printer with the clamp portion of the bracket pointing down. Fasten bracket to the pair of 2020 V-Slot rails using two M5 x 10mm cap screws, then slide the pump into place and clamp with a M4 screw and nut. Take note the pump is slid into the clamp far enough to avoid obstructing the cooling holes!