Download Free 3D Model Sticky Pad Holder 3D Print Model

Summary
This simple sticky pad holder was born out of necessity. I use a lot of sticky pads at work for marking up paperwork, flagging key pages in giant binders, writing down the day’s tasks, etc. I wanted a one-handed sticky note solution for both sizes of sticky notes that my office stocks, so I took a lunch break and designed one.
This fits two sizes of sticky notes: The standard 3″ x 3″ sticky note, and the slightly less common 1.5″ x 2″ sticky note. I over-sized the compartments by .050″ in each direction (e.g. 3.050″ x 3.050″ and 1.550″ x 2.050″) to accommodate for tolerances in the sticky note manufacturing process. I tested several different pads of both sizes, and they all seemed to fit pretty well.
I printed this on a Markforged Eiger Onyx One with 4 floor/ceiling layers, 2 wall layers, and 50% triangular infill. The filament I used was Onyx chopped carbon fiber filament.
Possible design improvements include:
Adding a recessed square on the bottom for a piece of double-sided tape
Slightly larger and/or lower cut-outs in the front for easier access
Thinner floor/walls for a faster print time
Increasing the height to stack multiple sticky pads
Happy printing!