Download Free 3D Model Nut Driver Set Holder 3D Print Model

Summary
I’m not sure if this exact nut driver set holder will be of any use to others, but I am putting it up here so someone else might benefit from my design.
I inherited a set of nut drivers without a case. I wanted to wall mount them and wanted them to stay put in the wall mount. The bottom piece holds small rare earth magnets (6mm or 8mm in diameter x 3mm thick). These hold the nut drivers in securely in place while still allowing them to be easily removed. The magnets are a tight fit and need to be pressed in place. I also put a drop of super glue on the edge of each magnet to make sure that they don’t accidentally come out.
Assembling this is a tight fit. I had to put the pieces together on the floor, stand on the top piece and jump a tiny bit. After that I then used a rubber mallet to get them to sit fully flush. I put in three screw holes which probably aren’t necessary, but hey, over engineering is the American way!