Download Free 3D Model Naza Mount for QAV 180mm quadcopter 3D Print Model

Summary
An organised mount for Naza with the new version PMU/LED combo. Also has a provision for two 1.65mm brass power rails in place of a power distribution board as well as a camera mount for an Eachine MC-02 AIO camera. You will need 300mm of brass for the power rails, 4 m3x10-12mm bolts, naza m lite or v2 with the combined PMU/LED and an mc 02 camera or similar.
This was designed on the clone frame available from ebay for around 10USD. When built with 2403 2300kv motors, FVT little bee 20a esc’s and a 1300mah 3s 30c pack you can expect flight times between 6 and 10 minutes.
Print Settings
Printer:
Tronxy a3 Rafts:
No Supports:
Yes Resolution:
~.08 Infill:
10-100% Notes:
This is a fairly easy print, no special settings required aside from support for a couple of sections which could be cut out post printing if you choose. The PMU is a very tight fit and is intended to have a clear diffuser between it and the frame. The PMU’s plastic case and heat shrink must be removed for it to be installed. A dab of rubber cement or something similar will be required to keep the PMU and FC in place. All wires can be run under the FC and attached to the rails for a very clean install.
Post-Printing
The longitudinal holes for the power rails will likely need reaming as they are designed with very tight tolerances for a friction fit.