Download Free 3D Model Hobby Lobby Hunter/Tornado suspension arms 3D Print Model

Summary
Longer suspension arms for the Hobby Lobby Hunter & Tornado RC cars from the early 80’s.
Front and rear track will go up 60mm total.
The front A-Arms have print in place ball joints. Before use, rotate the ball 180 degrees. The cup in the ball is designed to firmly hold the front axle knuckle king pin pivots.
Zero caster and camber.
Upper arms were designed to maximize shock travel and angle within the space provided. This created a much more damped feel, but you will probably need to adjust your spring perches.
Lower arms were designed to accept anti roll bar end links.
Rear upper arms were designed for equal length suspension.
Bump stops are setup for ~40 degrees total movement. ~20 degrees at max droop and compression. This should help keep the dog bones from popping out and for sure will keep them from binding against the drive cups.
As much as possible, all hardware is reused but you will need to source a few things.
Required parts:
4x HPI Dogbone #101064. But any dogbone that is 90mm long from center to center, and has 8mm drive balls will work.
Longer steering links
8x M3 x 18mm screws
8x M3 nylock nuts
I’m fairly certain, like 99%, that these will bolt right up to a Robbe Pantera, Serpent Cobra, and Graupner Hunter.
I’m 100% certain these will bolt right up to a Skyward Labs Mean Mudder.