Download Free 3D Model Cubicle Hook 3D Print Model

Summary
Changed jobs, came to work in an office full of cubicles. Found that the hooks that clip onto the top of the cubicle wall were a little hard to find, so I decided to borrow one & copy it. Took some measurements & made this my first ever project in Fusion 360. I purposely did not make it banjo-tight across the top of the cubicle wall, as I wanted to be able to try both PLA and ASA (I use ASA instead of ABS, but it has similar properties). I have only printed them in ASA, because it has some flex to it. I suspect PLA will work fine, since it won’t have to flex too much, but it might be a tad brittle & prone to stress cracking, depending on each filament brand’s properties.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
.28mm
Infill:
50% rectangular
Notes:
With such a small/thin part, it’s all about perimeter strength. I used 4 solid top/bottom/perimeters in S3D, and 50% infill, because there is barely any infill after those perimeters, so it’s not really much of a waste.