Summary
Alright, well don’t get your hopes up. Without dampers, better bearings, stiffer chassis and the ability to make fine adjustments a selfie stick still works better. However this does demonstrate the general principle.
It is designed to use 624ZZ bearings like these: https://www.amazon.com/gp/product/B071CFN91S
M4 nuts/bolts like these: https://www.amazon.com/gp/product/B017N7ZI72
Springs like these: https://www.homedepot.com/p/Everbilt-Spring-Assortment-Kit-84-Pack-13554/203133714
However you can get the general idea using the printed bearing and pin with a few rubber bands.
Print Settings
Printer Brand:
Prusa Printer:
Prusa Clone Rafts:
No Supports:
Yes Resolution:
I used 0.2 with a 0.3mm nozzle Infill:
20% Notes:
Lay the struts, gimbal and platform pieces down flat so the “grain” goes the right way for strength.
Post-Printing
Assembly:
Press in the bearings and screw the parts together. The Mount piece has a slot to insert a nut.
There are several pegs to use for the springs, pick a set of springs and pegs that work with the weight of your camera.
The mount was made for my G16 which is a larger point and shoot camera. You will probably have to shim the camera up until it just rights itself.
Warning! Use a wrist strap attached to the camera or photograph over a pillow.
Mini Camera Gimbal 3D Print Model
