Download Free 3D Model Micro quadrocopter frame – semiducted – Beecheese frame V4 3D Print Model

Summary
Enjoy my new 3d design for a brushless micro quadrocopter. It uses 2.5 inch propeller and 2S lipo at dys 7000kv 1104 motors. The AUW of the micro quadcopter is around 170grams using a 850mah battery pack. The flightcontrolboard is flashed with betaflight 3.3 at standart PID settings. Only rates adjusted.
I could not do a full speed test, but it seems to have quite some power.
It should be around 150 grams per motor with 2S and the 2540 tribalde props.
If you have some flexible filament you may print the tpu motor mounts to reduce vibrations on your frame. For me this worked quite good.
You may also try to print the short standoffs using tpu. In addition i mounted my fc board onto slices of “oropax” earplugs. This works quite well.
It will fit M3 screws for the frame standoffs and the 30mm flightboards. (10x)
Use M2 screws for the flight boards with a diameter of 20mm or 16mm (4 – 12x)
I have also added a tiny bit screwdriver, in case you have troubles reaching the cam mount, you might find it usefull.
I would be very happy to see your make and get some feedback 🙂
Build and first testflights:https://youtu.be/CC2rdLjDmQU
Components:
Motors
DYS 1104 7000KVhttps://goo.gl/mGteyH (link to quadrocopter-teile.at)
Props:
Gemfan flash – 2540 – tribladehttps://goo.gl/qYrMwk (Link to banggood.com)
ESC
Racestar 4 in 1 12A using DSHOT 600https://goo.gl/CWm5G1 (Link to banggood.com)
Recommended flightcontrol
Omnibus F4 with OSDhttps://goo.gl/3BXv5Z (link to banggood.com)
FPV cam/transmitter combo – TX05 (great image quality for its size, very leightweight)https://goo.gl/tX1n3Q
5V active Buzzer (take it, if you dont want to search your quad for hours and hours.)https://goo.gl/ud4U5G (Link to banggood.com)
Further you need:
Transmitter and receiver of your choice. I use the Flysky I6 with SBUS modhttps://goo.gl/GwRqK4 (Link to banggood.com)
FPV goggle of your choice.
I use the Kylin Vision with Eachine DVR mod:https://goo.gl/1OyqmI
Print Settings
Printer Brand:
MakerBot Printer:
MakerBot Replicator (5th Generation) Resolution:
0,3 Infill:
45% Notes:
for a complete set you need:
PLA:
1x quadrocopter frame
3x standoff long
4x standoff short
1x tx03 cam mount
TPU:
8x standoff very short (optional PLA)
4x TPU motor mount