Download Free 3D Model TX Flysky i6 hand PAD

Summary
Here’s a set of hand pad that I created to hold well this thin i6 transmitter from Flysky.
I printed them without any support, standing, be careful there’s not much touching bottom layer, you can try adding manual support.
Polygon look is wanted.
I drilled holes on my tx with a 2.6ish mm mesh than screw metal 3mm hex screw.
If you want to try first, I could image you print it as vase mode first maybe.
Print Settings
Printer Brand:
RepRap Printer:
RepRap Kossel Rafts:
No Supports:
No Resolution:
0.2 Infill:
a few Notes:
bottom, top and wall at like 4 layers to get it tough. But not much infill, maybe around 8%. It took around 6h to print one at an average of 30mm/s