Download Free 3D Model Joined Swiming Lure (Fabric Printing) 3D Print Model

Summary
This is a work in Progress and the lure has NOT been tested yet!
This is just a prototype for an idea I’m playing around with using the new technique of printing on fabric. I did not come up with this idea I am just trying to find new creative ways of using it. I believe the original idea came from Shorey Designs from Instagram.
The design of the lure was just a rough 10 minute design I came up with to try this idea. I have no idea if it will actually swim correctly as I have not tested it yet. I am posting the file already because other expressed interest in trying it themselves.

The Printing Process.

The process starts by printing a few layers (two In this case) and then pausing the print.

The tulle fabric was then taped to the bed over the print.

The print was then resumed and continues to print over the fabric imbedding it into the print.

The finshed print.

The fabric acts as a hinge allowing the lure to bend.

I add tie on/hook points and a little wieght (.177 BB’s) and then superglue the two havles together.

The finished lure before painting.

Wiggle wiggle wiggle……
This video shows the entire process.