Download Free 3D Model Dropcam Pro Window Mount 3D Print Model

Summary
This is a Dropcam Pro window mount based on the window mount by robcurtis, however, I remixed it to eliminate the blind-spots (in the corners of the video) caused by the original design’s round aperture. I also added two additional holes, which I can only assume are present for drainage of any moisture/humidity that may build-up within the mount once it’s on the window. This design holds the camera at a 15-degree angle to the window, just as the original design.
Print Settings
Printer:
Creality CR-10 Rafts:
No Supports:
No Resolution:
0.1-0.2 Infill:
25% Notes:
I printed this using a 10mm brim because of the rather narrow bed contact area, but it could probably be printed as-is if you have good bed adhesion. Otherwise, no supports are needed and anything from 20%-25% infill will provide plenty of structure and strength.