z axis manually fine-tuning platform, this model is made up and down by the turbine worm, and used as a large z-axis fine tuning platform.This model is transformed into step and iges general model download, please refer to!Also includes 3d original files, welcome to download!if you like,you can paypal for you to get this models or if you have any questions also you can email to me.
Tag: Z-Axis
-
Creality Ender-2 Z-axis stabilizer mount v2 3D Print Model
Summary
New version.
This is a Z-axis leadscrew stabilizer for Creality Ender-2.
Print, drill out the main hole with a 8-9mm drill bit, it might be a good idea to use some grease as well when installing it. Before you tighten the screws, move the Z axis to the top to position the stabilizer correctly.
Print Settings
Printer:
Ender-2 Rafts:
No Supports:
No Resolution:
.15 Infill:
100% Notes:
Use either 100% infill or lower infill and thick walls, I used 25% infill and 1.6mm walls -
Z-Axis Stabiliser for Anet A8 3D Print Model
Summary
A useful tool to stabilize the z-Axis.
An alternative to the already existing things.
Post-Printing -
Additional Z-Axis Stabilizer for Wanhao D7 3D Print Model
Summary
Adds another stabilizing rod to the z-axis on the Wanhao D7. Work in progress. Alignment is not perfect and required a little torch action on base piece to soften PLA to fit! -
Anet A8 Z-Axis Rod Stabilizers 3D Print Model
Summary
These parts will improve the stability of your Z-Axis. Designed with very tight tolerances to pressure fit the rods yet spin freely on the frame. No need for bearings or screws. Just print two.
Print Settings
Printer:
Anet A8 Rafts:
Doesn’t Matter Supports:
No Resolution:
0.1mm Infill:
25% -
Z-Axis Balance Gauge 3D Print Model
Summary
I made a gauge as an index when adjusting the Z axis screw balance.
With this gauge you can easily and quickly adjust the balance of the Z axis.
Designed for JG AURORA A3.
The height of the gauge was 48 mm.
The gauge is approximately 0.5mm higher than the zero position of the z axis.
Print Settings
Printer:
JG AURORA A3 Rafts:
No Supports:
Yes Resolution:
ABS Layer:0.2mm Nozzle:0.4mm Infill:
20% -
Z-axis Wobble Isolation Bearing Blocks 3D Print Model
Summary
Isolated bearing blocks for Z-axis. No mounts for brass nuts.
Left bearing block has been scalloped, to allow Y-axis trigger switch to be mounted from the rear.
Right bearing block has been scalloped to allow recessed idler pulley arm.
Appropriate idler pulley arm included in file bundle.
Use with integrated Z-axis wobble isolation risers here: https://www.thingiverse.com/thing:2458534 -
Tronxy X5 Z-axis Holder 3D Print Model
Summary
Hey,
some more Spareparts for the Tronxy x5.
I will customize it as soon as possible for you. -
3mm/5mm Z-Axis Shim for Flashforge Creator Pro Glass Bed 3D Print Model
Summary
3mm/5mm Z-Axis Shim for Flashforge Creator Pro Glass Bed