3DHunt.co

Tag: X5s

  • Tronxy X5S dual PSU Hanger 3D Print Model

    Tronxy X5S dual PSU Hanger 3D Print Model

    Summary
    The original used too much plastic. I added some holes to make it lighter and use less plastic. Should keep the same rigidity.
    Print Settings
    Printer:
    Tronxy X5S
    Rafts:
    No
    Supports:
    No
    Resolution:
    .2 mm
    Infill:
    20%

    How I Designed This
    Remixed it in Tinkercad

  • Tronxy X5s Z axis printed split bushing 3D Print Model

    Tronxy X5s Z axis printed split bushing 3D Print Model

    Summary
    When building my Tronxy X5s, I was not impressed by the stock Z axis bearings. So I designed and printed a replacement system. The bushing has a split in it and you slide the sleeve over it and tighten it with 2 M3 screws and nuts. I printed the bushing in PLA and the Sleeve in PETG, but you could print it in PLA. There is also a short version in which a IGUS RJ4JP-01-08 sits on top of it and both are held and tightened by the sleeve. This was created for the people who do not like PLA bushings.
    Print Settings
    Printer:
    SmartRap – Highly modifed
    Rafts:
    No
    Supports:
    No
    Resolution:
    .2
    Infill:
    30
    Notes:
    Set up the number of shells to be enough to create the bushing vertical section without any infill. Allowing the shells to make up the “fingers” of the inner part of the bushing. Mine was 3 shells.
    How I Designed This
    Designed in Fusion 360