3DHunt.co

Tag: UMX

  • E-Flite UMX Prop Adapter 3D Print Model

    E-Flite UMX Prop Adapter 3D Print Model

    Summary
    Replacement prop adapter for E-flite Ultra Micro (UMX) airplanes. Replaces EFLU4067, this should work on any UMX airplane which uses the 180-size brushless motor. This will still break in the event of a crash, protecting the rest of the aircraft.
    This is set up to run just the prop, length has been adjusted so no spinner/backplate are required.
    Holes should be good to go, the 3 mounting holes may need slight enlargement – I do this by just twisting an X-acto knife around in there a couple of times.
    Print Settings
    Printer:
    XYZ Da Vinci Mini w Rafts:
    No Supports:
    No Resolution:
    0.2mm Infill:
    50% Notes:
    Printed with XYZ Da Vinci Mini w at 0.2mm layer height, 50% infill, +10C temperature (black PLA) and 40mm/sec retract speed. I highly recommend using a brim to ensure that this stays level and true.
    How I Designed This
    Designed in eMachineShop.

  • Parkzone UMX P-51 display stand 3D Print Model

    Parkzone UMX P-51 display stand 3D Print Model

    Summary
    Just a nice little stand for the Parkzone umx P-51D 🙂 Prints In about 4-5 hours
    Print Settings
    Printer:
    Anet A8 Rafts:
    No Supports:
    No Resolution:
    .2mm-.3mm Infill:
    20%