3DHunt.co

Tag: Ultimaker

  • Ultimaker 2 Titan Fixture 3D Print Model

    Ultimaker 2 Titan Fixture 3D Print Model

    Summary
    The motor shaft of most of the steppers is too short as to use it inside the UM2 to connect the Titan Feeder.
    Therefore i made this 90° angled fixtures for the Titan to use the existing holes.
    Print Settings
    Printer Brand:
    Prusa
    Printer:
    Prusa Clone
    Rafts:
    Doesn’t Matter
    Supports:
    Doesn’t Matter
    Resolution:
    0.3
    Infill:
    20%

  • Ultimaker 3 Filament Guide 3D Print Model

    Ultimaker 3 Filament Guide 3D Print Model

    Summary
    Since this was requested quite a few times by our customers, we have decided to develop an easily printable filament guide.
    This was designed for the Ultimaker 3 series but will work on an Ultimaker 2+ as well since they share the same feeder on which the guide is to be mounted.
    We welcome any suggestions you may have in regards to the improvement of this filament guide.
    Print Settings
    Printer Brand:
    Ultimaker Printer:
    Ultimaker 3 Rafts:
    No Supports:
    Yes Notes:
    Supports are needed at the mounting point.
    Post-Printing
    Mounting the filament guide.
    To mount this filament guide, you will need an M3 x 25 screw, since the original is not long enough.

  • Ultimaker Hotend Cap 3D Print Model

    Ultimaker Hotend Cap 3D Print Model

    Summary
    I liked maggiman2001’s design but wanted the opening to be in the middle since my SanjiuPrinter is dual extruder. I also used a chamferred edge on the long side.
    Print Settings
    Printer:
    SanjiuPrinter Z360 Rafts:
    No Supports:
    No Resolution:
    .1 Layer height .4 nozzle Infill:
    20%