3DHunt.co

Tag: toothed

  • Toothed Clip/Clamp 3D Print Model

    Toothed Clip/Clamp 3D Print Model

    Summary
    I made this clip to hold coiled exercise bands so that they wouldn’t flop around. However, it can be used for anything that would benefit from being compressed together like extension cords, audio cables, etc. One could modify it to have a bigger arm radius or be longer/short depending on your needs. I’d also considered putting a loop on one side so that it could be hung on a wall or work station.
    Demo: https://youtu.be/4lMVi9G0CzM
    Print Settings
    Printer Brand:
    Prusa Printer:
    i3 MK2 MMU Rafts:
    Doesn’t Matter Supports:
    Yes Resolution:
    .15mm Infill:
    25% Notes:
    I printed both pieces on their sides. Supports were used under the teeth and the arm on Body A. The printer manages fine bridging across the ‘roof’ of the female piece fine, so no supports are needed inside that hole.
    Post-Printing
    Depending on the your printers accuracy, you may need to take an X-Acto knife to the male end so that it can slide easily in and out of the receiving piece.

  • X-axis tensioner for use with toothed idler. 3D Print Model

    X-axis tensioner for use with toothed idler. 3D Print Model

    Summary
    I recently released a x tensioner for use with my own x axis parts. This version is based upon the same design but with a few modifications to suit a stock x axis on the Anet A8 (The version with ABS printed x axis sides though it may work with the injection moulded parts too!)
    This is oriented as intended for printing with supports built in. You will need to cut away the supports on the underside of the two prongs, the supports inside the central rectangular hole and most (not all) of the cylinder in the center.
    You should ideally leave an equal amount of the central cylinder on either side such that the idler wheel is barely able to move from side to side but can rotate freely when mounted.
    My first print of this is not ideal as I had set the bed level incorrectly and had a belt tension problem at the time. I will be reprinting.
    Print Settings
    Printer:
    Anet A8 Rafts:
    No Supports:
    No Resolution:
    0.4mm nozzle and 0.32mm layer (0.2 would also be fine!) Infill:
    50% but you can probably get away with a bit less
    Post-Printing
    Supports will need to be removed from the model after printing and before fitting. You will also need 3 sets of m3 screw and nut to hold the idler in place and fit to the top and bottom of the part to allow you to adjust the screws to tweak the tension in the x axis belt.
    How I Designed This
    A few modifications on a previous OpenSCAD design used in my version of the x axis idler and motor mounts. Slightly thicker walls to accomodate recesses for nut and screw head on the idler hole, thinner prongs due to available space and slightly increased gap for the idler to be mounted.

  • Dolphins 3D Model

    Dolphins 3D Model

    dolphin porpoises delphinid aeanimal bottlenose flipper Tursiops truncatus toothed aquatic fish whale realistic game scanline low poly pose morph jump

  • Killer Whale Orca Skull 3D Model

    Killer Whale Orca Skull 3D Model

    High quality 3d model of killer whale orca skull.2 versions for 3ds Max included : V-Ray and standard materials.Previews rendered with V-Ray………………………………………..NOTE: Complete killer whale skeleton available as separate product, see product ID: 1158597