3DHunt.co

Tag: strain

  • TEVO Tornado Ultrabase Upgrade Remix with cable strain relief 3D Print Model

    TEVO Tornado Ultrabase Upgrade Remix with cable strain relief 3D Print Model

    Summary
    Clamps to attach Anycubic Ultrabase to the Tevo Tornado.
    Added cable strain relief to the rear left part.
    Remixed this https://www.thingiverse.com/thing:2782720 and this https://www.thingiverse.com/thing:2748197 things.

  • Creality Ender 4 strain relief 3D Print Model

    Creality Ender 4 strain relief 3D Print Model

    Summary
    I wanted a strain relief bracket which didn’t interfere with the bed levelling screws – instead, one that clamped the bed carriage would be ideal using m3 hardware
    The one I made is v1. This is version 2, featuring an angle to avoid screws contacting the bed, nut retainer insets and slightly narrowed. I reduced the diameter of the cable channel to get a tighter cinch with the cable ties.
    To complete, use two m3 10mm or 12mm bolts and nuts to clamp the carriage, and two small cable ties, just push them through.
    Print Settings
    Printer:
    Creality Ender 4 Rafts:
    No Supports:
    Doesn’t Matter Resolution:
    0.32mm Infill:
    20 Notes:
    To print, rotate onto its side, it shouldn’t need supports though a brim may help. If using PLA, print it slightly hotter than normal (PLA+ settings) to increase interlayer bonding. Printed 215-220 deg C to increase strength.
    Infill doesn’t really matter, 3 perimeters / 1.2mm wall is what I used, it’s more than enough.
    How I Designed This
    Designed in Onshape from scratch, if you want to edit it the link is here:https://cad.onshape.com/documents/2d61c918ed37344b6f5f4652/w/5cc150713efcf0918f92af5e/e/7c914fb3f0feff55238d9b94

  • TEVO Tornado Rigid Strain Relief for Heat Bed 3D Print Model

    TEVO Tornado Rigid Strain Relief for Heat Bed 3D Print Model

    Summary
    Rotate 90 degrees. No support.

  • Bowden tube strain relief used on extruder motor 1.75mm 3D Print Model

    Bowden tube strain relief used on extruder motor 1.75mm 3D Print Model

    Summary
    I created this to relieve the strain on the bowden tube pneumatic connector on the extruder motor for 1.75mm filaments. It has been tested and is working great. This should pretty much fit all pneumatic connectors with 10mm diameters from face to face on the flat sides and can be used on the extruder motor or the effector end.
    Print Settings
    Printer:
    FLSUN Delta Supports:
    Yes Resolution:
    .2 mm Infill:
    30%