Summary
This is a design for mounting the PCB of the Sonoff Basic on the rail inside a consumer distribution box (Mains electric box, power distribution box)
This has not been tested, since my printer is broken for now.
USE THIS AT YOUR OWN RISK
I do not recommend using this in the same box as your power Breakers (MCB, FI, fuses etc.)
Make sure you know what you are doing.
This is technically not the right dimensions as a single slot MCB, since the Relay of the Sonoff is as tall as that, but I didn’t want it to take 2 MCB slots.
Requirements
Sonoff Basic PCB:
with a removed push button or shortened push button “shaft” &
and led either bend, or removed,
if you are using one of the designs with the LED and button holes you can use some wire to extend them to the face
4x M3x25 screws
4x M3x18 screws
2x M3x10 screws
6x M3 nuts
4x M3 square nuts
4x M3 washers (optional)
4x Screw terminal crimp (preferably one that has a hole so it doesn’t get of while installing)
1x Small spring
