3DHunt.co

Tag: Snapmaker

  • [Snapmaker] Moth Minimal Spool Holder 3D Print Model

    [Snapmaker] Moth Minimal Spool Holder 3D Print Model

    Summary
    Moth styled Minimal Spool Holder.
    Heavily inspired by Kelvin8rs Minimal Spool Reel Guidehttps://www.thingiverse.com/thing:2844100
    Requires 4 608RS bearings.
    Printed with PETG, but anything should do 🙂 Some flex is best though!

  • Snapmaker Pi Camera Mount & Holder 3D Print Model

    Snapmaker Pi Camera Mount & Holder 3D Print Model

    Summary
    This is an attachment for mounting a Raspberry Pi Camera to the Snapmaker if you’re running OctoPrint.
    The arm swings from the front to 90 degrees to the right side of the printer bed. There are notches in the base in 15 degree increments.
    The Pi Camera case and bracket are taken from this mount https://www.thingiverse.com/thing:2265949.
    Everything is snap fit, except for mounting the base to the printer and mounting the arm to the base. Details in Print Settings below.
    Print Settings
    Printer:
    Snapmaker
    Rafts:
    No
    Supports:
    No
    Resolution:
    0.2mm
    Infill:
    20%
    Notes:
    You will need
    4 x m4x8mm bolts to attach the base to the Snapmaker.
    1 x m4x20mm bolt and nut to secure the swing arm to the base.