Summary
ive tested this and the belt moves freely behind the bracket and the breakout board is still mounted below for clean wiring
Print Settings
Rafts:
No Supports:
Yes Resolution:
.2mm layer height
Tag: RJ45
-
rj45 dual breakout board mount for maker713 light for ft-5 3D Print Model
-
RJ45 Ethernet 5-hole Cable Holder 3D Print Model
Summary
Very simple 5-hole Ethernet cable organizer. 5 holes to accommodate WLAN + 4 other cables. -
6x RJ45 mount 3D Print Model
Summary
For my Ramps 1.4 box this bank of RJ45 plugs is used for the stepper and endstop cables. Each cable feeds only one stepper with two leads for each connection. Pressure fitted into the box and the connectors into the mount.
-
Low Profile RJ45 breakout 3D Print Model
Summary
The original seemed a bit bulky, so I trimmed it down to roughly half the original thickness, leaving all other dimensions the same. -
RJ45 Breakout Mount 3D Print Model
Summary
RJ45 Breakout Mount for rewiring with CAT6 network cable.
Print Settings
Printer Brand:
SeeMeCNC Printer:
Rostock MAX v2 Rafts:
No Supports:
No Resolution:
.25 Infill:
30% Notes:
Used ABS