3DHunt.co

Tag: revised

  • Triforce Smartphone Stand Revised 3D Print Model

    Triforce Smartphone Stand Revised 3D Print Model

    Summary
    This is a minor remix of Rem3_1415926’s Triforce Smartphone Stand. It replaces the inward-sloping shelf with a level shelf and lip — this may hold your phone better.
    Thanks, Rem3, for the attractive design!

  • Revised MPCNC Belt Mount/Tensioner 3D Print Model

    Revised MPCNC Belt Mount/Tensioner 3D Print Model

    Summary
    I liked DodgeDerek’s redesign of the MPCNC Belt Mounts, but for some reason the tabs did not fit my prints of the corner blocks, so I made a new version adjusted to fit. I also adjusted the exit point of the belt for a more linear pull from the “ear” of the corner block. The other part I redesigned is the belt clip. I changed it to engage the belt all the way around the clip instead of just on the top and bottom. Finally, I modified the nut trap to accept a 4-40 nut instead of the metric size that was in the original.
    I am using these on my functioning MPCNC and they have thus far worked out very well.
    Print Settings
    Printer:
    XYZ DaVinci Jr. 1.0
    Rafts:
    No
    Supports:
    No
    Resolution:
    0.2mm layer height
    Infill:
    25%
    Notes:
    3 perimeters using PLA

  • Drum Key Key Chain (Revised) 3D Print Model

    Drum Key Key Chain (Revised) 3D Print Model

    Summary
    This is a drumkey I made. There is a hole in it to attach it to a keychain.
    All measurements are made in inches.This was revised for 3d printing, so the support goes all the way into the handle to minimize overhang, and also the hole was filleted for better utility.

  • Fuji X mount revised extension tube 3D Print Model

    Fuji X mount revised extension tube 3D Print Model

    Summary
    After printing the original extension tube designed by IGFARM, I realized that at least on my X_T2, it didn’t lock into place on the camera. I widened the camera contact surface and put in the slot for the pin to lock it into place. I rotated the orientation that he had it in by 180 degrees, so the only support needed is for the top tabs.
    Print Settings
    Printer Brand:
    Wanhao Printer:
    Wanhao Duplicator i3 V2 Rafts:
    No Supports:
    Yes Resolution:
    .1 Infill:
    15% Notes:
    I printed it on a Monoprice IIIP using PLA at 205 degrees with 100% cooling
    Post-Printing
    Redesigned face

    Mounted to my camera

    How I Designed This
    Not having spent the time to learn the better CAD programs, I did this redesign in Tinkercad.