3DHunt.co

Tag: retaining

  • Filament roll retaining clip 3D Print Model

    Filament roll retaining clip 3D Print Model

    Summary
    I designed these to hold 1.75mm filament to the edge of the reel to avoid bending the filament as when you use the holes on the edge of the reels. These are designed for the specific brand I use(3D spark) so they may not fit your particular reels. Try the single part first before printing the 12 x nest of parts,
    I will also leave a STEP file so people can adjust the gap to fit their needs as they see fit.
    I found that using 2 of they per reel worked best.
    Print Settings
    Printer:
    tevo tarantula Rafts:
    No Supports:
    No Resolution:
    0.2mm Infill:
    20%
    Post-Printing
    If the hole is a little small, use a 2mm or 5/64″ drill to clean out the hole.

  • Caravan door retaining shaft 3D Print Model

    Caravan door retaining shaft 3D Print Model

    Summary
    The door retainer on my Abbey Aventura snapped, so I drew another one. Fits well, maybe too well 🙂 I would scale to 99% to print again, though a light sand should sort it.
    Print Settings
    Printer:
    CTC Prusa i3 Pro B Rafts:
    Yes Supports:
    Yes Resolution:
    0.15 Infill:
    50% Notes:
    I printed this laid on it’s side with supports for the shaft, as you need it so that the strength is in the right place