3DHunt.co

Tag: redesign

  • Redesign wheel castors for video skate dolly 3D Print Model

    Redesign wheel castors for video skate dolly 3D Print Model

    Summary
    This wheel castors was re-design for who not have anywheel.
    It can spin freely in any direction.
    It’s use 33×38 mm castors, 4×15 mm screw, and 7 mm nuts.
    Refer to https://www.thingiverse.com/thing:357568
    Print Settings
    Printer:
    Creality CR-8
    Rafts:
    Doesn’t Matter
    Supports:
    Doesn’t Matter
    Resolution:
    0.3 mm per layer
    Infill:
    20%

  • LOL Clock redesign 3D Print Model

    LOL Clock redesign 3D Print Model

    Summary
    This is a remake of robaux’s LOL Clock (https://www.thingiverse.com/thing:2219658). A new back piece 18mm thinner than the original has holes for the power socket and buttons.
    A new circuit design has been done that uses two LED constant current drivers and five MOSFETs row drivers. There are two PCBs. One to hold all the LEDs (board is cut in half so that it can go in the case) and the second board holds the Arduino Mini, DS1307 RTC, DC-DC Buck convertor, Constant current LED drivers/shift registers and some buttons to set the time.
    All Eagle files and Arduino sketch have been included along with the new back STL file. I made my boards using the toner method. The board contains SMD components because that is what I had on hand.
    ……………………………
    To set the time:
    Press the MODE button, the hours will flash 5 times a second
    Use the UP and DOWN buttons to set the hours
    Press the MODE button, the minutes will flash 5 times a second
    Use the UP and DOWN buttons to set the minutes
    Press the MODE button and the normal time mode is shown. (denoted by the colon separator flashing once a second).

  • Flsun i3 x/z axis 45 mm redesign

    Flsun i3 x/z axis 45 mm redesign

    Summary
    I’ve decided to make a version of my x/z-axis redesign with a center to center distance for the x-axis rods of 45 mm, with the belt centered. There have been many requests from certain people who want to use a prusa carriage with their flsun printer, so if you’d like to print an original prusa carriage with 45mm rod spacing and the belt centered, these are the brackets for your flsun i3!
    For reference, this is the complete redesign with the original 70 mm spacing. Many people have reported success with this design alternative also.http://www.thingiverse.com/thing:2116748