Tag: RadioRay

Summary
I purchased a set of GoLight RadioRay LEDs for my truck and I also got the Flood Lens set for both of them. These lens are really nice but I prefer the focus beam generally so these lens need a safe home while gettin tossed around in my old beat up truck.
So I designed this case and if I print it twice, I have a case for each lens 😉
There isn’t much special about this except that it works exactly as I wanted. The only post printing suggest I would have is to add some thin foam to ensure the lens doesn’t get scratched while in the case however the lens do not move around much as is. Still, I added the foam since I get enough packaging foam things shipped in so I had something that was perfect already 🙂
Print Settings
Printer Brand:
LulzBot Printer:
TAZ 5 Rafts:
No Supports:
No Resolution:
.25 Infill:
15% Notes:
This is a “box” with no details so no need to get super fancy on your resolution; just whatever prints the fastest for you.
I went with PLA because it has a greater chance for dimensional accuracy and my PEI sheet is finally giving up on me with bubbles at 100C so ABS just isn’t working out so well however even with a few bad prints in ABS, the case still performed well.
I recommend a low infill simply because this will hold up due to size and shape.
I used 1.5mm perimeter and top/bottom and that may be more than it needed. Honestly I wouldn’t be surprised if I could set this under my truck’s tire and run it over and it’ll still hold up. Might test that out with a failed job later 😀