3DHunt.co

Tag: Nema17

  • Conduit Crane Machine NEMA17 Axis Mount 3D Print Model

    Conduit Crane Machine NEMA17 Axis Mount 3D Print Model

    Summary
    Using this for a conduit crane machine.
    Will post rest of machine as it is built.

  • Staffa nema17 48 mm estruso 3030 3 3D Print Model

    Staffa nema17 48 mm estruso 3030 3 3D Print Model

    Summary
    Staffa nema 17 per estruso 3030
    Altro https://www.thingiverse.com/thing:2755114
    Altro https://www.thingiverse.com/thing:2755366

  • 1:15 Gearbox For Nema17 3D Print Model

    1:15 Gearbox For Nema17 3D Print Model

    Summary
    use for ….

  • Nema17 Motor Strap 3D Print Model

    Nema17 Motor Strap 3D Print Model

    Summary
    While working on a couple of xyz da vinci jr 1.0 units I noticed they kept having issue’s with feeding which was due to the pneumatic fitting loosing strength and allowing the bowden tubing to come loose causing complete loss of tension for pushing the filament through the hotend. To resolve the issue I took the feeder motor out of the unit and replaced the feeder portions attached to the motor with an aluminum extruder block off amazon (https://www.amazon.com/gp/product/B014SB12Q2/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1)
    One other thing to note, I also replaced the hotend of the unit using a hotend off amazon as well (https://www.amazon.com/gp/product/B01GD8LCFO/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1) so I am not sure if the pneumatic fitting from the stock bowden tube works with the block linked above.
    I then needed a way to mount the moto back to the framing and after searching around thingiverse and not finding something usefull I came up with this simple design.
    Some day I will get around to creating an actual hot end mount that is compatible with the xyz da vinci jr carriage. Until then I just used one I found on here.
    Print Settings
    Printer Brand:
    Robo 3D Printer:
    R1 ABS + PLA Model Rafts:
    Doesn’t Matter Supports:
    Doesn’t Matter