Summary
This is a remix of mmoore0s great power supply cover. I made the original and broke 2 of them while mounting so I reinforced 3 of the sides and also added the MK2 mounting lug so I could mount it on my clone. It would allow you to use the larger meanwell on any MK2 style frame though. I also, rather than drilling the frame, added the included block and used it with double sided tape to secure the top of the power supply to the frame. I think you could leave that off and the screws at the bottom would be enough to hold it in place if your printer doesnt move much but I just wanted to make sure the top was secured to the frame. I printed the one in the pictures with E3D edge crystal. It looks good and has done the job well so far.
Tag: Meanwell
-
Meanwell NES-350-12 Cover for MK2 3D Print Model
-
End cap for Meanwell LRS-350-12 3D Print Model
Summary
Wanted an end cap for my meanwell that would allow me to easily disconnect my Ender-2. The xt60 and xt30 just push in and are a tight enough fit that they shouldn’t go anywhere but you can always add a drop of glue to them. Links for the parts I used are below.
Voltmeter:https://www.amazon.com/gp/product/B00C58D47G/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
IEC socket:https://www.amazon.com/gp/product/B01LYMNQ2L/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
XT60:https://www.amazon.com/gp/product/B073QJWVVK/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
XT30:https://www.amazon.com/gp/product/B074S7NH3H/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
Power Cord:https://www.amazon.com/gp/product/B005VULXA0/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
Meanwell LRS-350-12 Power Supply:https://holiday.lighting/psorderform
Print Settings
Printer:
Ender-2
Rafts:
No
Supports:
Yes
Resolution:
0.28
Infill:
20
Notes:
Supports only needed on the hole for the voltmeter