3DHunt.co

Tag: Makies

  • Makies Pumpkin Candy Bowl 3D Print Model

    Makies Pumpkin Candy Bowl 3D Print Model

    Summary
    Custom brim for a 3x scaled Makies Pumpkin Base — Makes a nice Halloween Candy Bowl
    I was printing a 3x scaled Makies Pumpkin and was 85 to 86% complete when the print died. (Was printing from SD card but host machine in lab was rebooted and to my surprise/disgust the two machines that were printed directly from SD card also stopped when the host went down) Rather than waste 18 hours of print time and half a roll of filament I came up with a lid/brim that covered the exposed infill and reasonably salvaged this print for an alternative use. I printed it in black PLA and felt it was too start so I then printed this brim in Orange PLA and I am happy with the result.
    Print Settings
    Printer Brand:
    LulzBot Printer:
    TAZ 6 Rafts:
    No Supports:
    No Resolution:
    0.25mm Infill:
    20% Notes:
    Prints fine w/o a brim.
    Pause or kill your pumpkin body print at 85 or 86%. Then print this cover. Use Loctite 401 to glue the cover onto the pumpkin body. Enjoy