Summary
Due to the slack of the leadscrew nut on the stock sparkmaker unit.. i make a replacement for it.
This nut is around 7mm thick.. if you need a longer type, do pm me.. i will upload.
NOTE.. After print .. DO grease and run Through the Nut with the leadscrew first, it kind of tight.. Once it has go through and re-assemble back to the unit, recommend to run the liner movement print code and let it finish the whole cycle.. 🙂
Print Settings
Printer:
Anycubic kossel min K2
Rafts:
Doesn’t Matter
Supports:
No
Resolution:
0.1
Infill:
100
Notes:
Type of filament reco for this application:
-POM
-PP
-PLA
Do print with 100% infill to ensure the parts are strong.
Tag: Leadscrew
-
Sparkmaker Replacement Leadscrew nut 3D Print Model
-
Prusa Steel X axis with tensioner and 8mm leadscrew support 3D Print Model
Summary
This X axis for the Prusa steel frame features a convenient single screw belt tensioner and supports 8mm leadscrews.
You need some M3 screws and nuts to mount the leadscrew nuts in place, a M4 screw and nut for the tensioner and a M5 screw and nut for the toothed idler, I use a cheap aliexpress toothed idler with a M5 bore.
Prints without supports.
Print Settings
Printer Brand:
Prusa Printer:
Prusa Steel Rafts:
Doesn’t Matter Supports:
No Resolution:
0.3-0.25 Infill:
25-30% -
Tronxy x3 Z leadscrew stabilizer bearing support 3D Print Model
Summary
I needed a stabilizer that would house a 16mm bearing, as that is all I had. So I designed these instead of using the 22mm 608z skate bearings. The bearing is a 16x5x8. Enjoy.
Print Settings
Printer:
Tronxy X3 Rafts:
No Supports:
Doesn’t Matter Resolution:
.2 ish Infill:
your liking -
10mm Smooth Rod with T8 Leadscrew Version of Blackrocks X-Carriage 3D Print Model
Summary
Im on a mission to eliminate z banding, so 10mm smooth rods and Leadscrews is the goal.
Once im finished with the design will upload solidworks files.
I know there was a request for a 10mm version quite some time ago, and if there are anymore requests now is the time 😀