3DHunt.co

Tag: Greg´s

  • Greg’s Bait Bomb – Bait Rocket – Spod – Carp Fishing 3D Print Model

    Greg’s Bait Bomb – Bait Rocket – Spod – Carp Fishing 3D Print Model

    Summary
    A simple Bait Rocket (Spod) Design. the original one is small, you can cast it with a regular carp rod. no support required, the inside has a dome shape. I tried it in my bathtub and it works and floats properly, still need to test it in real conditions.
    Print Settings
    Printer:
    CR-10s
    Rafts:
    No
    Supports:
    No
    Resolution:
    0.2
    Infill:
    No
    Notes:
    few infill or none in order to make it float correctly. Walls are 1.5mm to make it as watertight as possible. I still advice you to spray a lacquer coat or two on it, you don’t want any water to enter in the head/float part.
    How I Designed This
    Fusion 360

  • Greg´s Extruder 9:47 3D Print Model

    Greg´s Extruder 9:47 3D Print Model

    Summary
    Well this is a remix of https://www.thingiverse.com/thing:961630 extruder, with very little changes to satisfy my needs. One of that is 9:47 gears ratio that in my case give me a 24mm3/s filament flow with 1.75mm filament. This design use:
    3 – 608 bearing
    1 – M8 50mm Hobbed Bolt with hob centered at 23.5mm (this can be changed with washers to your needs).
    1 – M8 Self Locking Nut
    1 – Nema 17 Motor
    2 – M4 Allen Bolt 54mm long
    2 – M4 Hex Bolt
    2 – M4 Washer (to hold pressure springs)
    2 – Extruder Pressure Springs
    1 – M3 shaft to hold idler. A m3 bolt with nut can be used.