Summary
This is an ABS holder for the FrSky XM receiver, has slots for a small zip tie but not needed. The XM slides right in and you can solder on the 90 degree 3 pin and cut short so it barely pokes out the bottom. Print in ABS 75-80% infill.
Tag: Frsky
-
FrSky XM RX Stack Holder 3D Print Model
-
3DR solo quadcopter drone 3d model vray 3D Model
modelled for subdiviosion smoothing.Ready for production render
-
3DR solo quadcopter drone 3d model 3D Model
modelled for subdiviosion smoothing.Ready for production render
-
U842 Sport racing QUadCopter 3d model vray 3D Model
U 842 sport racing quadcopter drone,modelled for subdiviosion smoothing.Ready for production render
-
Micro Quad fpv Racer 100mm Brushless 1S 0703 20.000kv 3D Print Model
Here is a mini racer 100mm made of polycarbonate equipped with brushless 0703 1S version 20.000kv.
-
Woop 105mm Indestructible TPU 1103 7800kv 3S 3D Print Model
Here is a mini quad turbine in TPU with 1103 brushless motors that accepts the 3S with the propellers 4 blades and 2S with the 5 blades.
The chassis and the lipo door are in TPU Ultimaker and the top plate in Polycarbonate or ABS to rigidify the whole.
It takes 20% filling for the frame with 230 ° on a carpet at 70 ° at a speed of 30mm / s. -
Frsky Horus x12s Mount for Rlink Transmitter 3D Print Model
Summary
printed with flex filament
Print Settings
Printer:
tevo tarentula Rafts:
Doesn’t Matter Supports:
Yes Infill:
30 Notes:
printed with flex filament