Summary
I needed to move my amp rack back a couple feet but the cables weren’t long enough, my solution was to move my speakon connectors from the back of the rack to the front as the individual speaker leads were easier to lengthen than the 8 conductor speakon cable.
The bracket was made in tinkercad in less than ten minutes but the printing took four hours.
It fits the 8 conductor speakon flanged outlet nicely.
The sound system was featured in this article, https://kioskfan.wordpress.com/2013/08/26/designing-a-crossover-exposes-more-faults-than-solutions/
Print Settings
Printer:
DMS DP5 Rafts:
No Supports:
No Infill:
22% Notes:
Cheap PLA, it’s just a bracket.
Tag: flange
-
Speakon flange bracket (double) 3D Print Model
-
Omnistand 53mm spool holder with large 80mm flange 3D Print Model
Summary
A larger spool holder with a larger flange to prevent the filament roll running over the little flange on the one provided with the omnistand V1.36 by BaronWilliamshttps://www.thingiverse.com/thing:652415
Pretty simple print. Print with the flange at the bottom. -
Flange that accepts pool cleaner hose. 3D Print Model
Summary
A simple flange with a 41mm inner diameter. Can be bolted to a tank.
Print Settings
Printer:
XYZPrintingDa Vinci JR. 1.0 Rafts:
No Supports:
No Resolution:
Doesn’t matter. Infill:
Did mine at 50% no problems. -
Gate Valve 3D Model
Gate Valvesmoothable modeltextures includedPolygonal quads onlyHigh quality polygonal model – correctly scaled accurate representation of the original objectsModels: 1 objectsmulti/sub-materialQuads: 70386points: 37618
-
Valve thermo 3D Model
Valve thermosmoothable modeltextures includedPolygonal quads onlyHigh quality polygonal model – correctly scaled accurate representation of the original objectsModels: 2 objectsmulti/sub-materialQuads: 12158points: 12810