3DHunt.co

Tag: Eachine

  • Eachine Googles Two monitor enclosure conversion 3D Print Model

    Eachine Googles Two monitor enclosure conversion 3D Print Model

    Summary
    Custom enclosure to convert a Eachine Googles Two over to monitor.
    Works great, but be adviced that it the screen is to small to use for flying. Perfect for spectating. Can be improved, but works good enough for now.
    No additional parts needed.
    Print Settings
    Printer:
    Anycubic i3 Mega

  • Realacc X210 CAM MOUNT Eachine C800T CCD 3D Print Model

    Realacc X210 CAM MOUNT Eachine C800T CCD 3D Print Model

    Summary
    As the standard Realacc X210 Frame cant hold CCD cameras I came up with a solution.
    This is a holder for the “Eachine C800T 1/2.7 CCD 800TVL 2.5mm” (banggoods name if u search it, u ll find it) or other FPV Cams which use a 25mm x 25mm housing.
    It is not able to do high camangles.
    Max is about 10 degrees. It´s design denies this, so u cant break your FC board by bending the cam onto it and destroying it when u crash.
    Contact me if u need any other format / informations / changes.

  • Eachine Wizard X220 Runcam2 Mobius camera mount small 3D Print Model

    Eachine Wizard X220 Runcam2 Mobius camera mount small 3D Print Model

    Summary
    This is a shorter camera mount to fit a Runcam2 (or similar) on the top deck of an Eachine Wizard without limiting the room for the battery (up to 3S 1800 mAh).
    Printed in ABS.

  • Eachine VR D2 Side Cover for glasses 3D Print Model

    Eachine VR D2 Side Cover for glasses 3D Print Model

    Summary
    I wear glasses and cannot fit the Eachine VR D2 goggles on with my glasses. I took apart the goggles, cut out a small section on each side and hot glued this printed cover to block out light. Simple print, works pretty well!
    Print Settings
    Rafts:
    Doesn’t Matter Supports:
    Yes Resolution:
    .2 Infill:
    25%

  • Eachine Wizard X220 POD 3D Print Model

    Eachine Wizard X220 POD 3D Print Model

    Summary
    Remix of spaceone pod. Not pretty, and haven’t even tested to see if this fits or not. Made to replace top section of drone. The battery will have to be bottom mounted. Havent figured this one out yet. Work in Progress

  • Eachine Wizard 220 gopro mount 25deg 3D Print Model

    Eachine Wizard 220 gopro mount 25deg 3D Print Model

    Summary
    simple quick design for a gopro mount for the eachine wizard x220.
    I based the bolt spacing on Brandoncook’s design, its a very similar design, but made from scratch.
    not printed or tested yet,
    suggest ABS or TPU/TPE, at least 50% infill, better 100% for strength!)
    Supports probably needed for the strap hole.