Compass 3D modelHigh poly 3d model of a Compass.Model is fully textured with all materials applied.Model does not include any backgrounds or scenes used in preview images.
Tag: diameter)
-
18mm to 16mm screw diameter adapter for 8X zoom lens 3D Print Model
Summary
My friend bought a phone case that lets him screw on an 8x zoom lens. the problem is that the screw was too small. So I made this adapter that allows it to screw right in. I thought this may be useful to a few people so I decided to just upload it. Enjoy.
It’s an 18mm female to 16mm male.
Post-Printing -
Reducing coupling 3D Model
Modeled in blender of 2.79.All the names of the meshes and materials have logical names.The number of polygons/vertices without the use of modifiers: 5.657/5.884.All pivot points aligned.Preview made using render Cycles.Scene file (.blend) ready to render.Materials made in Cycles.
-
Fitting plug 3D Model
Modeled in blender of 2.79.All the names of the meshes and materials have logical names.The number of polygons/vertices without the use of modifiers: 2,968/3,162.All pivot points aligned.Preview made using render Cycles.Scene file (.blend) ready to render.Materials made in Cycles.
-
Clutch PB 3D Model
Modeled in blender of 2.79.All the names of the meshes and materials have logical names.The number of polygons/vertices without the use of modifiers: 4.459/4.622All pivot points aligned.Preview made using render Cycles.Scene file (.blend) ready to render.Materials made in Cycles.
-
Blank Medal 50mm Image Diameter / Medalla en Blanco para Imagen de 50mm 3D Print Model
Summary
For fast printing < 10 min:
Layer Height: 0.29
Top Layers: 3
Bottom Layers: 2
Perimeter Shells: 1 -
Ferris Wheel with Platforms (24cm diameter) 3D Print Model
Summary
This is a 24cm-diameter ferris wheel. It is designed to sit in a fixed position, and it has 60 platforms (30 on each side), each 2.5cm square. The platforms can be used to put figurines or anything else that can fit.
There are four distinct types of pieces. You need 4 each of the two orientations of the quarter wheel, and 1 each of the stand, male wheel connector, and female wheel connector.
Post-Printing
The included pieces are sufficient to make the ferris wheel stand up on its own. However, to increase the stability, I added small pieces of velcro to the flat sides of the wheel pieces. I also made room for you to insert a 1/2-inch ceramic magnet into the wheel connector to increase the connecting force and make the two pieces less likely to break apart.
How I Designed This
I designed all of the parts using FreeCAD. I am grateful to the FreeCAD community for their help in learning how to use their wonderful software.