Game ready realistic polar bear cub.Model has edge loop based topology.All materials & textures are included.Included Textures are: Color Map, Normal Map, Specular Map.Texture Size : 1024 pixel x 1024 pixel.Model is render ready.
Tag: Cub
-
Photorealistic Panther Cub 3D Model
Highly detailed photorealistic 3d model of Panther Cub.This model has been modeled with a clean topology based on quads and loops. It is ready to be rigged and smoothable. Perfect anatomy and skin shading makes this model good for closeup render.Eyeballs, teeth, tongue and gum are included.The model is provided with high resolution (4k) texturesIncluded Textures are:01 Color Map02 Specular Map03 Normal Map04 Alpha MapAll Texture Size : 4000px X 4000pxThe model is render ready & ready for use in animation.Note:- Model is directly usable in:- Maya 2014 or Above, 3dsmax 2014 or Above, Cinema 4D R16 or Above and in other 3d application through FBX or OBJ formats.
-
FT Cub Rear Wing Support 3D Print Model
Summary
Upgrade part for the Flite Test Simple Cub RC airplane
When built to the plans the back of the wing that sits on the fuselage does not have a lot of support. The force that the rubber bands exert on the wing can fold the back part of the wing and mess up the wing angle. Two of these supports attached to the wing in that problem area will correct the problem.
I printed two supports with PLA, roughed up the surfaces to glue with sandpaper, and then hot glued the supports in place.
The position of the supports is a few millimeters in from the edge of the fuselage with the wing mounted to leave a bit of space for some rubber band protectors.
I also smear a thin layer of hot glue over the area of the wing that contacts the fuselage to better hold it in place so it doesn’t slide around. This includes the surface of the supports.
Print Settings
Printer Brand:
Wanhao Printer:
Wanhao Duplicator i3 V2 Rafts:
No Supports:
No Resolution:
0.2mm Infill:
100% -
super cub battery holder system 3D Print Model
Summary
A system to hold a battery in place in a Super Cub. The tray holder goes in the top and the battery tray hooks onto the holder -
Pivot bushing for cub cadet rzt-50 3D Print Model
Summary
I lost the pivot bushing out of the front axle of my rzt-50 from cub cadet. It’s a tight fit, but works
Print Settings
Printer Brand:
Prusa Printer:
Prusa Clone Rafts:
No Supports:
No Resolution:
.3 Infill:
100 Notes:
printed 100 percent infill for strength -
Cub Cadet Deck Height Adjustment Button
Summary
Designed for my Cub Cadet HDS 2155 on which the deck height button had long been broken. Its a simple cylinder with a chamfer(.125″ if I remember correctly) on the top and 1/4-20 threads .75″ deep. This was modeled in Fusion 360.
Print Settings
Printer Brand:
Prusa Printer:
Prusa Clone Rafts:
No Supports:
No Resolution:
.12 Infill:
100%
