Summary
This is the base plate where you would mount your losi micro crawler or trekker transmission. This is a very small piece so the lower you can go with the resolution the better the print will turn out. If you don’t have a printer that can handle very fine detail go with the version with no indentation as it is a lot easier to print and does the same job. I have provided two bolt patterns on the same design, the first one is base pattern, the other one is offset to mount transmission closer to the right side allowing for closer to center driveshaft location.
Print Settings
Printer:
Monoprice Select Mini Upgraded
Rafts:
Doesn’t Matter
Supports:
No
Resolution:
as low as you can go
Infill:
85%
Tag: Crawler/Trekker
-
Losi Micro Crawler/Trekker Base plate 3D Print Model