3DHunt.co

Tag: Caliburn

  • Caliburn Extended Barrel Shroud 3D Print Model

    Caliburn Extended Barrel Shroud 3D Print Model

    Summary
    This is designed to cover longer Caliburn Barrels, over 18″.
    All parts except for rail print without support. Requires 4 10-32 screws.
    You’ll need to split the shroud into two parts.
    Inspired by, but completely distinct from the original Argus Modworks barrel shroud.
    Designed at the request of a customer.
    etsy.com/shop/remzak

  • Cealyn the Caliburn – Scar Barrel Reinforcement 3D Print Model

    Cealyn the Caliburn – Scar Barrel Reinforcement 3D Print Model

    Summary
    The retaining arms on my Caliburn SCAR Barrel broke on my first print, and started to weaken on my second, so I made a quick reinforcement piece. This not only helps to hold the retaining arms so they will be less likely to break, but it makes the whole SCAR barrel operate a little more tightly.
    I included an obj, which should hopefully be set up correctly, but I am unsure as I model in Blender.
    It is good fodder for visual modifications, as it does not have to twist, and sits on top of the barrel.
    Enjoy, and feel free to give suggestions, or remix!

  • One-piece Caliburn Foregrip 3D Print Model

    One-piece Caliburn Foregrip 3D Print Model

    Summary
    Remixed from Caliburn (Captain Slug) and user Misery5567 (AR-15 Skeleton Foregrip)

  • Caliburn MuzzleVF1 Friction Fit 3D Print Model

    Caliburn MuzzleVF1 Friction Fit 3D Print Model

    Summary
    This is a quick modification to Slug’s Caliburn MuzzleVF1 file, which is an extended muzzle break essentially. It is a friction fit onto the aluminum barrel and doesn’t require screws to be attached. I found that the muzzle would be off-axis from the barrel because of the single screw point and I wanted it to work for when I eventually swap out for a longer barrel.

  • Caliburn – Lower Stock Reinforcement 3D Print Model

    Caliburn – Lower Stock Reinforcement 3D Print Model

    Summary
    This is a reinforcment part for https://www.thingiverse.com/thing:2376150.
    I printed my Caliburn in PETG, which is more flexible than the PLA the designer intended the blaster to be printed in. The stock_alt2 part would be spread apart by the clear tube at the end when the threaded rods were tightened, enough to reduce catch’s reliability. Rather than print an entire new blaster in PLA, I made this part which keeps the threaded rods and stock_alt2 from spreading.
    Print Settings
    Printer:
    D300VS Rafts:
    No Supports:
    No Resolution:
    .2mm Infill:
    20% Notes:
    Rotate so it is standing vertically before printing

  • Plain Caliburn Magwell 3D Print Model

    Plain Caliburn Magwell 3D Print Model

    Summary
    This is a Caliburn magwell section without any words, so you can add your own words or markings there.
    *You might notice the letter outlines in the preview but it shouldn’t show up in the print, toggle Thingview to confirm.