Summary
Why
This is a quick design for an autolevel probe that should fit most Delta effectors like the Anycubic Kossel, FLsun etc. etc.
The probe is specifically made to support Delta printers with effectors that clamp the top end of a bowden V6 extruder. It’s probably too short for a V5 hotend.
Features
Fits most Delta effectors
Designed to match the e3d v6 hotend in length
Uses standard M3 mounting hardware (nut and bolts)
Uses standard endstop switch
Instructions
Print it in PETG with multiple walls and slow speed to get the strongest part.
Print without a fan to get the strongest part.
No supports required
If you encounter inconsistent bed leveling, your effector may not be entirely level. Mount the probe closer to the center, or upgrade to a hotend-mounted autolevel probe.
Open Source
As always the original design file (fusion360) is included, so feel free to improve it (or learn from it)!
Tag: Autolevel
-
Autolevel mount for V6 delta printers 3D Print Model
-
autolevel anet a8 3D Print Model
Summary
autonivel with effective and economic proximity sensor.
is installed directly at end of stroke z axis.
without changes in skinet just as the capacitive does not modify anything. -
Anet Autolevel sensor mount(V6 hotend + Bowden) 3D Print Model
Summary
I originally printed the first one. I really like the design. The only problem is that the sensor sits too low to use the v6 hotend with a bowden extrusion setup. The highest you can raise it on the original, you were stil about 4mm away from the print surface.
So I chopped it a bit to make it higher, and gave it some more adjustment room.
I have not tested it. I haven’t had a chance to print it yet as the printer is not quite together yet.