3DHunt.co

Tag: AFG

  • Keymod Mini AFG 3D Print Model

    Keymod Mini AFG 3D Print Model

    Summary
    Small AFG for Keymod rail, Odinworks inspired. Small but comfortable for a good hand angle if using a thumb over bore grip.
    I could only get it on with just the rear pin in place with the keymod screws i had which seemed short. It is still on there very solid.
    Print laying on its side with support only for 80 degree overhangs. I used PETG and .2 layer at 55mm per sec, 30% infill in Cura.
    Print Settings
    Printer:
    Anet A6
    Rafts:
    No
    Supports:
    Yes
    Resolution:
    .2
    Infill:
    30
    Notes:
    Print laying on its side, locating pins should be a press fit, I didnt use the forward pin and its solid.