Summary
Simple clamps for round lipped 30mm 40mm and 50mm model bases. Insert printed clamp into a 1/2″ pvc pipe coupler.
Print Settings
Printer:
i3 clone
Rafts:
No
Supports:
Doesn’t Matter
Resolution:
.3
Tag: 50mm
-
Round lip model base paint clamp 30mm 40mm 50mm 3D Print Model
-
Blank Medal 50mm Image Diameter / Medalla en Blanco para Imagen de 50mm 3D Print Model
Summary
For fast printing < 10 min:
Layer Height: 0.29
Top Layers: 3
Bottom Layers: 2
Perimeter Shells: 1 -
50mm Pulley (2x 608 bearing) 3D Print Model
Summary
This is a basic pulley. It has a 50mm main wheel and will handle up to a 10mm or 3/8″ line. You need two 608 skate bearings, and two 8mm x 35-40mm bolts and nuts. You can either tie a line to the top or use a carabiner as a clip. There are two wheel designs one fancy and one easier to print. I find that the wheels print well in the standing position with support. If you have problems printing that way the simpler design can be printed on its side. I may include a no bearing wheel very soon. The sides should be printed flat with 30% or more infill. I used 2mm walls, top and bottom with 30% infill. That basically makes the sides 100% with a little infill around the top block. There will be more variants, so stay tuned.
Enjoy.
If you like my designs why not tip me a dollar or two. Your support will allow me to spend more time on these designs and their variations. Thanks! -
50mm Blower Fan Nozzles 3D Print Model
Summary
These are some nozzles that I’ve designed for part cooling with my FLSUN delta. I had to make something new after upgrading to a knockoff volcano hotend.
There’s a few different designs. I currently use the V3.
Print Settings
Printer Brand:
Prusa Printer:
Prusa Mk2 Rafts:
No Supports:
No Resolution:
200 microns Infill:
5% Notes:
Make sure that your bridge settings are spot on, to get the best airflow.