3DHunt.co

Tag: 2mm

  • Prusa Lack Enclosure Door Handles for 20mm x 5mm x 2mm Magnets 3D Print Model

    Prusa Lack Enclosure Door Handles for 20mm x 5mm x 2mm Magnets 3D Print Model

    Summary
    Using the source files from the Prusa Lack enclosure, I resized the magnet inserts for 20mm x 5mm x 2mm magnets, which were easier to find on eBay.
    Print Settings
    Printer Brand:
    Prusa
    Printer:
    i3 MK3
    Rafts:
    No
    Supports:
    Doesn’t Matter
    Resolution:
    0.15 mm
    Infill:
    20%

  • Front panel 2mm lower USB/SD slot 3D Print Model

    Front panel 2mm lower USB/SD slot 3D Print Model

    Summary
    I remixed this front panel to be used with the X Gantry support since I do not use a side panel at all after installing this heat bed wiring mod.
    What I did was completely remove the factory metal side panel, then I printed the X Gantry support (In the remix list) and the spacer I designed. To cover the front side section, I printed the front panel which has the USB and SD card slots lowered 2 mm to accommodate the mod listed above.

  • chameleon swift 2mm support 3D Print Model

    chameleon swift 2mm support 3D Print Model

    Summary
    simple mais fonctionnelle. la tété des vis ne doit pas dépasser 1.5mm. il y a 2 modèle, un court et un de 2mm plus long comme sur la photo
    Simple but functional. The head of the screws must not exceed 1.5mm. There is 2 model, one short and one 2mm longer as in the photo

  • Ring 6mm diamond 3D Model

    Ring 6mm diamond 3D Model

    ring with 6mm main diamond and 2mm small diamond, best design