3DHunt.co

Tag: 2.0

  • Desk Organizer 2.0 3D Print Model

    Desk Organizer 2.0 3D Print Model

    Summary
    This is a remix of https://www.thingiverse.com/thing:1226652. I needed more space and a better/larger card holder. It’s pretty large. May not fit on some printers.
    Print Settings
    Printer:
    Folger Tech FT-5
    Rafts:
    No
    Supports:
    No
    Resolution:
    .25
    Infill:
    20%

  • Expandable Ant Fomicarium 2.0 3D Print Model

    Expandable Ant Fomicarium 2.0 3D Print Model

    Summary
    This is a remix of the expandable ant formicarium by dantius. It can store from 500-600 to 20 ants.
    (I know… it’s really messy)
    Print Settings
    Printer:
    Anet a8 Rafts:
    No Supports:
    No Resolution:
    0.2mm or less Infill:
    at least 20%
    Post-Printing

    Print

    Put acrylic or cut glass on top

    Put cotton in the slot and press it (not ultra-hard, you can break it)

    Put water in the cotton

    Cover all the exits with the “caps”

    I would recommend designing by yourself the entry hole for the tube

    Put ants inside very carefully or connect tube and wait for them to go in

    ENJOY!!!

  • MendelMax 2.0 Front Facing Fan Guard 3D Print Model

    MendelMax 2.0 Front Facing Fan Guard 3D Print Model

    Summary
    MendelMax 2.0 fan duct for my e3d and bltouch combo.

  • Transformers CW Posable Hands 2.0 Knuckles (remix) 3D Print Model

    Transformers CW Posable Hands 2.0 Knuckles (remix) 3D Print Model

    Summary
    This is a simple remix to re-orient the ball-joint version of the first knuckle on the fingers and thumbs of the Combiner Wars hands made by Sickofyou. The vertical orientation led to parts that would sheer off and cause breakage, while laying them vertically should produce greater durability and the ability to handle a little more force applied.
    I used Tinkercad to orient the parts, move the flat spot of the ball joints to the side it rests on, and reinforce the issues with the mesh caused by importing it into Tinkercad. Print with the same settings you would use for the originals!